Looking for a deeper explanation on the pin-slot alignment design

A Position GD&T is typically used to vary the location of a Feature of Size such as a hole, pin, slot, or tab In accordance with ISO standards,

Looking for a deeper explanation on the pin-slot alignment design RE: Dimensioning a single-ended slot​​ Your 13 dimension is defining the size of the feature, like the diameter of a hole etc

A Position GD&T is typically used to vary the location of a Feature of Size such as a hole, pin, slot, or tab In accordance with ISO standards,

slot magic To specify a slot feature using GD&T, you need to consider the size and location of the slot You can use a basic dimension to indicate the

How do you go about dimensioning slots in drawings? In SW I would create the dimensions, edit the radius one to add SLOT at the begining and

gd&t slot dimensioning A drawing would help us tremendously :agree1: OK, what are you looking for? Only dimension? Location of the slot? Are there any GD&T callouts

To keep the slot in line with the datum axis, position needs to be applied to the slots size dimension If the angle of the slot needs to be controlled better